Briggs & Stratton 31D707 Instructions d'exploitation télécharger pdf (Page 12)

4.0 INSTALLATION

4.1 LIFTING SYSTEM AND TRANSPORT

Unpack the machine and check that no parts

are missing or damaged. In case parts are

damaged during shipping, immediately con-

tact the carrier and manufacturer.

• Check that lifting device used is adequate to carry

the weight of the machine. See chart in 3.1

Techinical Data.

• Avoid lifting the machine over persons or things

that could get seriously hurt or damaged in case

of item falling.

• Before any lifting operations always announce it

to those around.

• Before lifting the machine, always be sure that

head is blocked in the center of the Guide Bars

using the Limit Rings, I (Ref. 4.2, Fig. 4).

To reduce volume and make transport/lifting operations

easier, dismount all four legs.

The machine is packed inside a carton box.

The machine is to be lifted by a forklift, placing it as

shown on Fig. 2.

4.2 MOUNTING AND DISASSEMBLING

All mounting and disassembling operations

must be done with machine “OFF” and un-

plugged.

• Proceed with mounting and disassembling opera-

tions very carefully wearing safety gloves and

proper footwear.

• Before placing the machine on the floor, keep it on

the forklift and screw on the legs with its

proper key A+B (Fig. 3).

• Lower the arms of the forklift and set the machine

carefully on the floor.

• Install the side table extension C (Fig. 3) and tighten

the knobs D (Fig. 3).

• Mount the fence on side part F+E (Fig. 3) and hold it

with proper Lever Knob G (Fig. 3).

Fig. 2

Locked

Lift points

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 63 64

Pas de commentaire

Briggs & Stratton 31D707 Instructions d'exploitation Page 12