Briggs & Stratton PRO400 Manuel d'instructions

PRO DRIVEE, G, & HGINSTRUCTIONSREIMANN & GEORGER CORPORATIONHOISTING PRODUCTS BUFFALO, NY P/N 6102076 7/28/03 For Serial Numbers C000100

6CAUTION:GASOLINE ENGINES ARE SHIPPED WITHOUT OIL IN THE CRANKCASE. ATTEMPTINGTO RUN THE ENGINE WITHOUT FILLING THE CRANKCASE AND REDUCER WITH OILWIL

73. To raise the load, first advance the throttle to increase the engine speed. Then lift the operator handle slowly with asmooth upward motion. Th

85 DISASSEMBLY5.1 PRIOR TO DISASSEMBLY1. Before disassembling the hoist, read and follow all the safety rules of this manual and related equipment

96 INSPECTION AND MAINTENANCE6.1 GENERAL MAINTENANCE RULES1. Proper maintenance of the PRO Drive and related equipment consists of adhering to all

106.4 OILING MECHANICAL PARTS1. The main bearings are lubricated for life and need no attention. Oil all pivots and linkage joints occasionally. 2.

116.6 ENGINE MAINTENANCEThe engine is guaranteed against defects by its manufacturer. Follow the manufacturer’s instructions for properlubrication a

12(b) Six randomly distributed broken wires in one rope lay. A rope lay is the length of rope along which one strandmakes a complete revolution arou

136.8 REPLACING PRO DRIVE WIRE ROPE1. Refer to Figure 6-2. Each end of the wire rope is equipped with loops. The small loop is attached to the brak

14Figure 6-3.PRO DRIVE BRAKE/CLUTCH CABLE ADJUSTMENT6.10 PRO DRIVE BRAKE ADJUSTMENT1. Lower platform completely and shut off PRO DRIVE. Turn off gas

154. Refer to Figure 6-4. Measure the length of the compressed brake spring only (B/N 11), located on the back of thebrake differential (B/N 9). The

PRE-HOISTING CHECKLISTThis checklist must be checked prior to each use of the PRO Drive. This checklist is to be used as a guideline inconjunction wi

167 TROUBLESHOOTINGThe following chart is intended to assist with troubleshooting the PRO Drive. While not all inclusive, the chart outlinesthe most

178 PARTS LISTSEach item number on the following parts lists can be matched with the item number shown on the correspondingassembly drawing as indica

18Figure 8-1.PRO Drive Gas Assembly Drawing

198.2 PRO DRIVE E ELECTRIC MODELRefer to Figure 8-2.Item Number Part Number Quantity Description1 0401309 1 OPERATOR HANDLE2 5800138 2 CLEVIS PIN3 040

21Figure 8-2.PRO Drive Electric Assembly Drawing

RGC HOISTING PRODUCTS PHONE: (716) 895-1156TABLE OF CONTENTSCHAPTER DESCRIPTION PAGE1 SAFETY ...

RGC HOISTING PRODUCTS PHONE: (716) 895-1156LIST OF FIGURESFIGURE DESCRIPTION PAGE2-1 PRO Drive Product Nameplate...

11 SAFETY1.1 INTRODUCTIONYour Reimann & Georger Corporation PRO Drive has been engineered to provide lifting performance, long termeconomics and

212. Do not remove material from the platform until it has stopped completely. 13. Keep out from under a raised load. 14. Never stand in-line with

32 SPECIFICATIONS2.1 PRO DRIVE SPECIFICATIONS MODEL POWER SOURCE ENGINE OIL CAP. FUEL CAP. PLUG GAPPRO Dri

43 INSTALLATION AND SETUP3.1 PRIOR TO SETUP1. Insure all structural members of the PRO Drive are free of defects and damage that may affect the int

54 OPERATION4.1 BEFORE OPERATING THE PRO DRIVEWARNING:A GOOD LINE OF COMMUNICATION MUST BE MAINTAINED BETWEEN THE HOISTOPERATOR AND THE ROOF CREW.1.